Golden Motor EPO-03HP, Руководство пользователя

Страница: 17 / 22

16
4 Maintenance
Clamp screw mounting models
When transporting or storing the outboard
motor while removed from a boat, keep the
outboard motor in the attitude shown.
TIP:
Place a towel or something similar under the
outboard motor to protect it from damage.
Storing outboard motor
When storing your outboard motor for prolonged
periods of time (2 months or longer), several
important procedures must be performed to prevent
excessive damage. It is advisable to have your
outboard motor serviced by an authorized dealer
prior to storage.However, you, the owner, with a
minimum of tools, can perform the following
procedures
·
Do not place the outboard motor on its side
before the cooling water has drained from it
completely, otherwise water may enter the cylinder
through the exhaust port and cause engine trouble.
·
Store the outboard motor in a dry, wellventilated
place, not in direct sunlight.
Procedure
Flushing in a test tank
·
Do not run the engine without supplying it with
cooling water. Either the engine water pump will be
damaged or the engine will be damaged from
overheating. Before starting the engine, be sure to
supply water to the cooling water passages.
1. Wash the outboard motor body using fresh
water. NOTICE: Do not spray water into
the air intake.
2. Remove the motor top cowling and silencer
cover. Remove the propeller.
4. Install the outboard motor on the test tank.
Fill the tank with fresh water to above the
level of the anticavitation plate. NOTICE: If
the fresh water level is below the level of
the anti-cavitation plate, or if the water
supply is insufficient, engine seizure may occur.