OPERATION
12
Heat Level Light Indicators
The LINCOLN Multi-Fuel Stove has five heat level settings that range from Low to High. This display serves multiple
purposes and you need to be familiar with these purposes. These five settings show you not only what heat level setting
the stove is operating on, but they will also show you what speed your convection blower is running. The lights will also
show you error diagnostic codes if your stove is not operating properly.
During normal operation one of the heat level lights will be lit up. As you press this
Heat Level
button you can increase
or decrease the heat level setting from Low to High. Whichever light is lit is the heat level setting you have the stove set
to. Keep in mind that when you change the heat level (either up or down), a change of one level will take effect in about
30 seconds. The second or third change will have a three minute delay between each change to allow the stove to adjust
to the new fuel rate.
For example, let’s assume that you are running the stove on the Low heat level. You want to increase the stove to the
third heat level setting to get more heat. Press the
Heat Level
advance button and the second light will come on. Press
it again, and the third light will come on. The
Power
light will begin to blink and the stove will almost immediately
change to the second heat level. Your auger feed rate and convection fan speed will also increase to the second heat
level setting. The stove will continue to function on the second heat level setting for three minutes. After three minutes
the auger feed rate and convection fan speed will then increase to the third heat level setting. Once the stove is
operating at the heat level setting you have put the stove on, the
Power
light will become solid again.
These heat level lights will also show you the speed of the convection blower. When you press the
Fan Speed
button
the Heat Level indicator light will immediately change to the level at which the convection blower is running. The light
will then blink for just a second, and then your heat level setting will again be displayed. Although you can increase your
convection fan speed above the heat level setting you are operating the unit on, you cannot lower it below the pre-
programmed speed for each heat level setting.
Error Codes
The Heat Level lights will also give you an error message if the stove is not functioning properly, or if the stove shuts
down during normal operation for some reason. This error message will be a flashing light on either the second or third
heat level. It is very important to take notice of which light is flashing if you are having trouble operating your stove.
This is a critical piece of information to supply to your dealer or the technical support department.
If the second light is flashing, this is an indication that the problem is related to airflow in the unit. Most of the time this
is related to a dirty stove or exhaust pipe. Cleaning your stove and/or exhaust pipe well will generally resolve this
problem. Also keep in mind that if you leave the viewing door open for more than 30 seconds the stove will shut down
and the second light will flash.
If the third light is flashing, this is an indication that either one of the thermodiscs has tripped or is not functioning
correctly, or perhaps you may have an auger jam.
See the troubleshooting guide towards the back of this manual for more detailed information about error codes and
troubleshooting procedures for your stove.
Содержание THE LINCOLN
Страница 27: ...ELECTRICAL DIAGRAM 23 ...
