Connecting the Cylinder (20 lb)
1. Turn cylinder valve hand wheel clockwise until it stops.
2. Make sure burner control knob is in the “OFF” position.
3. Position grill in open area that is level.
4. Position cylinder in safe location and where hose will be positioned to
prevent tripping.
5. Remove protective cap from gas connection plug on side of grill.
6. Attach the hose end of the regulator to the grill using “QUICK
DISCONNECT” instructions. (Figure 6.)
7. Connect regulator nipple into the cylinder valve. Make sure nipple is
centered in cylinder valve outlet. Tighten coupling nut by hand; do not
cross thread connection. (Figure 8.)
8. To disconnect make sure burner control knob is in the “OFF” position.
Close the cylinder valve by turning the handwheel clockwise until it
stops.
9. Loosen the coupling nut by turning it counterclockwise.
10. Remove hose end of regulator assembly from grill using “QUICK DISCONNECT” instructions. Place protective cap
back on gas connection plug and cylinder valve.
GAS CONNECTION (NATURAL GAS):
CAUTION:
Gas piping to your grill must be in accordance with local codes. In the absence of local codes, use the
national fuel gas code, ANSI Z 2231 (latest edition).
CAUTION:
Gas supply must be turned off at the grill when grill is not in use.
When ordered for natural gas the “TEXAS SIZZLER JR.”, comes adjusted for natural gas. A qualified gas installer should
install the gas line. A shut off valve should be installed at the grill.
1. Make sure burner control knob is in the “OFF” position.
2. Check regulator for debris or damage and replace if necessary.
3. Remove protective cap from gas connection plug on side of grill and attach regulator to plug using the Quick
Connect fitting. (Figure 6.)
4. Attach gas supply line to
3
/
8
” flare connector on inlet side of regulator.
5. To disconnect gas supply make sure burner control knob is in the “OFF” position and disconnect regulator quick
connect fitting. (Figure 6.)
6. Close gas supply shut off valve.
OPERATION:
WARNING:
Before lighting your grill, be sure to read this section carefully. When lighting your grill, always keep your
face and body as far away from the grill as possible.
Lighting the Grill:
1. Open cover.
2. Make sure burner control knob is in “OFF” position.
3. Turn on gas supply.
4. Depress and rotate burner control knob to “HIGH” position.
5. Depress igniter button, listen for clicking sound and check for burner flame.
Continued on next page
Figure 8.
4
