GAS CONNECTION:
The Texas Sizzler “JR” is offered in one of two gas types: LP or Natural Gas. LP models include pressure regulator and
quick connect adapter for disposable LP cylinders. (Pressure regulator, hose assembly and quick connect adapter for
20 lb. cylinder included with optional pedestal base or can be purchase separately.)
Natural Gas models include pressure regulator and quick connect adapter.
LP Gas Cylinder Safety:
NOTE: An LP gas cylinder is not provided with this grill. Only D.O.T. approved 16.4 oz. disposable, 20 lb or CAN/CGA-B339
approved (cylinders, spheres and tubes for the transportation of dangerous goods) LP gas cylinders should be used.
All approved cylinders must have an integral collar designed to protect the cylinder valve from damage. Do not use or try to
repair a damaged LP gas cylinder at any time. Contact your local LP gas supplier for replacement.
n
Do not fill your gas cylinder beyond
3
/
4
full.
n
Gas cylinders come with a pressure relief valve. If a cylinder is subjected to excess heat, the relief valve will open and let
highly flammable gas vapor and/or liquid escape. Do not store gas cylinders near an open flame or source of heat. Store
cylinders only in well ventilated areas.
Installing Your LP Gas Cylinder:
NOTE: For your safety, use only the regulator and hose assembly provided as original equipment with your grill.
NOTE: A fire extinguisher for Class A, B, C & D fires should be readily available at all times.
20 lb gas cylinder should be set upright so cylinder valve is at the top. This will ensure proper valve withdrawal.
Connecting the Cylinder: (16.4 oz) Disposable
1. Make sure burner control knob is in the “OFF” position.
2. Check regulator for debris or damage and replace if necessary.
3. Remove protective cap from gas connection plug on side of
grill and attach regulator to plug, using the “QUICK
DISCONNECT” instructions. (Figure 6.)
4. Remove protective cap from disposable tank and inspect
threaded connection for damage or debris and replace if
necessary.
5. Carefully thread cylinder onto regulator, making sure not to
cross thread connection.
6. Completed cylinder assembly as shown. (Figure 7.)
7. To disconnect cylinder make sure burner control knob is in
“OFF” position; unthread cylinder from regulator, place
protective cap on cylinder.
8. Disconnect regulator quick connect fitting. (Figure 6.)
Figure 6.
Quick Disconnect Connection
Figure 7.
3
1. To connect, push sleeve of socket toward
regulator. (Figure A.)
2. Position socket over plug and release
sleeve (Figure B.); sleeve will snap into
place when attached properly. (Figure C.)
3. To disconnect, push sleeve back and pull
out plug.
Continued on next page