1. Fill burner pan with silica sand supplied
with fireplace.
Note!
On L.P. models
vermiculite is used instead of silica sand.
Be careful not to pour vermiculite over
brass air mixer attached to burner pan. Air
mixer holes must not be obstructed!
2. Pour vermiculite over the CEBB (controlled
ember bed burner) tube creating a mound
effect over the tube. Do Not flatten out
vermiculite over tube.
3. Spread glowing embers over main burner
pan and CEBB tube.
Note!
Be sure to create
a gap between the main burner pan’s
glowing embers, thus enhancing a front
curl of flame from the main burner.
4. Pour black rock around sides of pan for
picture frame effect.
Note!
On L.P. models
be careful not to pour black rock over
brass air mixer attached to burner pan.
5. Position log grate against rear wall of
fireplace and center left to right.
6. CEBB burner is supplied with adjustment
valve and key to adjust front flame amount
to desired look. Key can be removed after
adjustment.
Gas Log Installation
10
Figure 9.2
Figure 9.3
Содержание EL GRANDE
