GOLDBRUNN THERM Goldbrunn 1450, Руководство пользователя

Страница: 24 / 88

EN
24
8. CONTROLLER OPERATION
When the temperature controller is on, the PV display shows the value of measured
temperature, and the SV display shows the preset temperature value.
Basic settings:
Temperature setting: Press the SET button, the PV display shows „SP” the SV displays
shows the adjustable temperature value. When last digit blinks, set its value with the
and buttons. Use the button to switch to the next digit and set its value
using and .
After setting the temperature, press the SET button to set the timer.
Timer setting: Press the SET button, the PV display shows „SI” the SV displays shows
the adjustable timer value. When last digit blinks, set its value with the
and
buttons. Use the button to switch to the next digit and set its value using and .
After setting the time, press the SET button for the device to start operation with the
defined parameters.
Advanced settings:
CAUTION: All the controllers and parameters have been thoroughly tested and
set by the manufacturer. If the functional parameters of the vacuum dryer meet your
expectations and if the vacuum dryer runs properly, there is no need to modify these
parameters.
How to open the advanced settings:
Press and hold , then press SET. The display will show „LCK”. Release the SET button
(while pressing ) and set the value of the blinking digit to „7”. Release and press
SET. The display will show „ALH”.
ALH – upper temperature limit alarm – set the desired value using and . The
device will set off an alarm when the sum of the preset and upper limit temperature
exceeds the actual temperature value. Available values: range of 0 to 100°C.
After setting the upper temperature limit alarm value press SET in order to adjust the
lower temperature limit alarm – the display will show “ALL”