fig.16
3
3
4
2
6
5
1
fig.17
USING THE PARALLEL CUTTING GUIDE AND
MITRE CUTTING GUIDE (Fig. 16)
The parallel cutting guide (1) can be used from both the left
and right side of the cutting disc.
• Gently turn locking knob (2) on parallel cutting guide
counter-clockwise to loosen.
• Adjust the parallel cutting guide in the desired position
using the parallel cutting guide scale (3), located on front and rear of table, to set
parallel cutting guide to desired width of cut.
• Turn locking knob clockwise to tighten securely.
To adjust angles:
• Slide mitre cutting guide (4) onto parallel cutting guide from the front.
Adjust parallel cutting guide to desired position and secure tightly.
• Adjust to desired angle using angle scale (5) and tighten securely with mitre
cutting guide locking knob (6).
TO MAKE A CROSS CUT (Fig. 17)
• Cross cuts are straight 90° cuts. The material is fed into
the cut at a 90° angle to the cutting disc. Using a marker
or grease pencil, mark the area to be cut on material.
• Adjust parallel cutting guide to desired position and
secure tightly.
• Place the material on the table and firmly against the
parallel cutting guide.
• Make sure the material is clear of the cutting disc before turning on the saw.
• Turn the On/Off switch to the
ON
position.
• Let the cutting disc get up to full speed and wait for the cutting disc to get wet
before moving the material into the cutting disc.
• Hold the material firmly against the parallel cutting guide and feed the material
into the cutting disc.
• When the cut is made, turn the saw
OFF
. Wait for the cutting disc to come to a
complete stop before removing any part of the material.
TO MAKE A 45° DIAGONAL CUT (Fig. 18)
45° diagonal cuts are also referred to as “cross cut”.
• Using a marker or grease pencil, mark the area to be
cut on material.
• Slide mitre cutting guide onto parallel guide from front.
• Set the parallel cutting guide to desired width, and tighten
the locking knob to secure in place.
• Adjust mitre cutting guide to 45° using angle scale and tighten securely with
locking knob.
• Make sure the material is clear of the cutting disc before turning on the saw.
• Turn the On/Off switch to the
ON
position.
17
OPERATION
fig.18
