CAUTION !
When fitting make sure that the cutting disc is placed correctly on the inner flange.
The inner flange can be moved freely on the motor shaft and has a section for
holding the internal hole of the cutting disc. The hole of the outer flange is not
round and is used for the interlocking connection with the motor shaft.
WARNING !
The metal bracket must always be aligned to the cutting
disc so that it does not Interfere with material being cut.
WARNING !
Product damage! Do not over-tighten hex bolt (3) and
locking knob (1). The upper protective guard (4) must be
free to rise and fall as the workpiece is pushed toward the
cutting disc.
13
ASSEMBLY
ASSEMBLE/ADJUST THE METAL BRACKET (Fig. 5)
• Loosen two cross-screws (1) with the Star-head
screwdriver (not supplied).
• Push slotted hole in the metal bracket (2) below the
cross-screw (1).
• Gently tighten the cross-screws (1).
• Align metal bracket (2) with the cutting disc (3).
• Tighten cross-screws (1).
• Replace the 45° vertical fence.
MOUNTING THE UPPER PROTECTIVE GUARD
(Fig. 6-7)
• Loosen the locking knob (1) and remove the locking knob,
flat washer (2) and hex bolt (3) from the upper protective
guard (4).
• Align upper protective guard (4) with cutting disc and
slide over metal bracket (5). Line up through holes in
upper protective guard with slot in metal bracket.
• Install hex bolt (3) through upper protective guard and
metal bracket. Put the flat washer (2) onto bolt before the
thread locking knob (1) and tighten the locking knob.
• Cover the cutting disc with the upper protective guard (4).
• Ensure that upper protective guard (4) can move freely
and that it cannot touch the cutting disc.
fig.5
3
3
1
1
2
2
fig.6
4
3
1 2
5
4
2
1
3
fig.7
fig.8
1
2
fig.9
2
MOUNTING THE EXTENSION TABLE (Fig. 8-10)
• Undo the cross-screws (1) on the guide rails of the
extension table (2).
