Goldair Select GSD170, Руководство по эксплуатации

Страница: 7 / 12

1. Remove the
water tank
3. Connect the
plastic tube
onto the water
outlet port
2. Remove the
rubber stopper
from the water
outlet port
4. Replace the
water tank
TIMER
When the unit is operating press the TIMER
button to set the length of time that you would
like the unit to run for before turning off. Each
press of the TIMER button will adjust the length
of time by 1 hour increments from 1
– 24hours.
To turn off the Timer function, set the Timer
back to
“ 00 ” hours or simply turn the unit off.
When the unit is Off press the TIMER button to
set the length of time that you would like the
unit to remain off before turning on. Each press
of the TIMER button will adjust the length of
time by 1 hour increments from 1
– 24hours. To
turn off the Timer function, set the Timer back
to
“ 00 ” hours or simply turn the unit on
manually.
WATER TANK FULL
A beep signal will sound 15 times. The WATER
FULL indicator light will illuminate on the control
panel. The compressor will stop automatically,
and the unit will stop dehumidifying.
Empty the water container and replace it in the
correct position. The appliance will continue
dehumidifying
when the compressor
automatically restarts after approximately three
minutes.
PERMANENT WATER DRAINAGE
It is possible to connect a drainage tube (not
supplied) to the unit for permanent water
drainage.
If this option is desired, you will need to
purchase a suitable tube from your local
hardware retailer. (Goldair Select does not hold
tubes as spare parts).
Ensure that the end of the tube is lower than
the drain opening, otherwise the water will not
drain and flooding may occur. Also ensure the
water tank is in position (in the unit) otherwise
the continuous drainage will not operate.
Place the end of the drainage tube in a drainage
outlet. When you no longer wish to use the
permanent water drainage, disconnect the
drainage tube from the device.
Operating your Appliance
WARNING!
Take care in
positioning your appliance, using
the timer will mean the unit will
come on automatically. Fire may
result
if placed next to
combustible material.