WARNING Keep all objects at least 1 metre from
the front, sides and rear of the appliance.
Note: When the heater is turned on for the first time, it
may release a slight, odour or smoke. This odour or
smoke is a normal occurrence caused by the initial
heating of the internal heating elements and should not
occur again.
HEAT CONTROL SWITCH
Check that the Power Switch at the back of the heater
is set to the Off position before plugging the heater in
and turning on the mains supply.
Turn the Power Switch at the back of the heater to the
“I” position. You will hear a beep.
The LED will display the current room temperature.
Press the Power button on the control panel to turn the
heater on, the unit will begin to blow out room
temperature air.
Press the Mode button and the heater will begin to
operate in Low Heat.
Press the Mode button a second time and the heater
will operate in High Heat mode.
Press the Mode button a third time and the heater will
operate in Fan only to blow room temperature air.
To turn the unit off, press the Power Button on the
control panel first and then turn the Power Switch at
the back of the heater to
“O” position.
Please note: the fan will continue to run even though
the elements have switched off. This is normal.
For greater economy, use the High Heat setting initially
and then switch to the Low Heat setting.
For the Low and High Heat settings the fan remains at
the same speed; only the element changes to create
the greater/lesser heat output.
THERMOSTAT
Use the
“+” and “-” buttons to adjust the temperature to
your desired setting (from 10-49°C). Once you have
set the desired temperature, the LED will display the
room temperature again and will rise as the room
temperature increases.
If the room temperature is below 22
℃
the unit will
operate in High Heat until the desired temperature is
reached.
If the room temperature is above 23
℃
the unit will
adjust to operate in Low Heat until the desired
temperature is reached.
The heater will now cycle on and off to maintain the set
temperature.
Always choose a safe location for the heater, keeping in mind the safety
precautions outlined. Ensure all packaging has been removed from the
unit before use. This appliance requires no installation, it should be used
solely as a portable appliance.
How the set temperature is maintained:
If the room temperature is higher than the set
temperature, the heater shuts Off automatically.
If the room temperature is lower than the set
temperature, the heater automatically switches itself
back On.
OSCILLATE
This button turns the heater oscillation function on
and off.
TIMER
Press the Timer button once, then use the Timer
button to adjust the length of time from 1
– 8hours
that you would like the heater to run for before turning
off. Each press of the Timer button will increase the
length of time in 1 hour increments before the unit
switches off.
The selected number of hours will set after 5 seconds
and will display on the LED screen. To turn off the
Timer setting function, set the Timer back to 0hours
or simply turn the unit off.
REMOTE
The remote control buttons perform the same
functions as those on the control panel of the unit.
For best results, aim the remote directly at the remote
sensor on the front panel of the heater. The remote
has a 3 metre range of operation.
The remote control requires one "CR2025" type
battery. Remove the plastic tab from the battery and
battery terminal prior to first use of the remote control.
Operating your Ceramic Tower Heater
MODE
BUTTON
OSCILLATE
THERMOSTAT
DOWN
THERMOSTAT
UP
TIMER
POWER
BUTTON
