1. Input selection LEDs
2. Input selection button
3. Output selection LEDs
4. Status LED
5. IR sensor
6. Function button
Quick start guide
DE: Bedienungsanleitung - de.startech.com
FR: Guide de l'utilisateur - fr.startech.com
ES: Guía del usuario - es.startech.com
IT: Guida per l'uso - it.startech.com
NL: Gebruiksaanwijzing - nl.startech.com
PT: Guia do usuário - pt.startech.com
Manual Revision: 12/01/2016
For the latest information, technical specifications, and support for
this product, please visit
Packaging contents
• 1 x HDBase-T repeater
• 1 x IR remote control
• 1 x universal power adapter (NA / UK / EU / AU)
• 1 x CAT5e cable
• 1 x mounting kit
• 1 x screw kit
• 1 x rubber foot pad set
• 1 x quick start guide
System requirements
• 1 x local HDBaseT video source or transmitter with cabling
• 1 x HDBaseT display or receiver with cabling
• 1 x HDMI source with cabling
• 1 x HDMI display with cabling
• 1 x remote destination HDBaseT display or receiver
HDBaseT™ Repeater - 4K
*actual product may vary from photos
Product overview
Front View
Rear View
1. Power adapter port
2. Grounding bolt
3. IR extender I/O ports
4. HDMI input port
5. HDBase-T input port
6. HDBase-T output port
7. HDMI output port
6
6
7
8 9
11
8. EDID switch
9. EDID copy buttons
10. RS232 switch
11. RS232 port
10
About this product
HDBaseT is a standardized, zero-latency video technology that’s
revolutionizing HDMI distribution. HDBaseT uses an advanced
method of modulation that enables you to distribute uncompressed
HDMI audio and video over long distances, over standard network
cabling.
This repeater receives your HDBaseT signal, and deploys it to an
additional receiver up to 70 m away, while outputting the HDBaseT
signal to an HDMI display at the repeaters location. The repeater also
enables you to add an HDMI source at the repeater’s location and
switch between sources at each connected HDMI and/or HDBaseT
display.
Preparing your site
1. At the local source, set up your HDBaseT video source, as
instructed by the documentation included with it.
2. Run your CAT5e or CAT6 cable from the RJ-45 output on the
HDBaseT source to the location you’d like to place the repeater.
Note:
This needs to be a direct connection. Do not route the cable
through any networking equipment.
3. Set up your HDMI display near the location you’d like to place the
repeater.
4. (Optional) Set up your HDMI source near the location you’d like to
place the repeater.
5. At the remote destination, if you’re connecting to an HDBaseT
display, set up the display appropriately in your desired location.
or
If you’re connecting to HDBaseT receiver with an HDMI display,
set up the display appropriately in your desired location and
connect your HDBaseT device to the display, as instructed by the
documentation that was included with your HDBaseT receiver.
Notes:
Please ensure that the repeater is situated near an
available AC power source. Make sure all devices are turned off
before you begin the installation.
