General Care and Safety Guide
SAFETY FEATURE
This heater is fitted with a thermal fuse in case
of overheating which is located inside the
construction of the heater. If this thermal fuse
operates it will turn the heater off but the light in
the power switch will remain on to let you know
there is still power going into the heater. In the
event that this happens, turn the heater off at
the switch and the wall socket and unplug it then
contact our Customer Service team.
IMPORTANT! NEVER COVER THIS HEATER!
PROOF OF PURCHASE
To receive warranty retain receipt as proof of
purchase. (Refer to back of booklet).
CARE AND CLEANING
Do not attempt to dismantle the Panel Heater.
There are no user serviceable parts. For service
or repair, contact an authorised electrical service
technician.
The heater requires regular cleaning to ensure
trouble free operation. Before cleaning, switch
off the heater and allow it to cool. Disconnect
the mains power supply cord. The outside can
be cleaned by wiping it over with a soft dry cloth.
NOTE: Do not use abrasive cleaning agents
or polish, this can damage the surface and
finish.
To remove the unit from the wall, simply remove
the bolt caps, unscrew the bolts with a screw
driver and then take the heater down.
For short term non-use, simply turn off the unit
with the power switch on the side of the heater
and disconnect the mains power supply at the
wall; for long term non-use, remove the unit from
the wall - simply remove the bolt caps, unscrew
the bolts with a screw driver and then take the
heater down
.
OVERVIEW OF YOUR ECOSAVE PANEL
HEATER
Your ecosave Panel Heater will provide controlled
background warmth by heating your room. The
surface of this Panel Heater can be painted with
good quality paint (acrylic or enamel).
OPERATING INSTRUCTIONS
Before plugging in and using your new ecosave
Panel Heater, check all surfaces to ensure the
heater is not damaged in any way.
After checking this, plug your heater in a mains
voltage plug corresponding to the rated output.
Use the On/Off Power Switch along the side of
the heater to turn your heater on.
SETTING THE THERMOSTAT
When first turned on the heater will display the
current temperature in the room on the display.
You can adjust the temperature to your desired
level by using the up and down arrows on the
thermostat display. The heater will then cycle
heat until the desired setting is met. It will then
cycle on and off to try and maintain the set
temperature. The temperature sensor (E) needs
to be pulled out to better read the ambient
temperature.
SUPPORT AND TECHNICAL ADVICE
PO Box 100707, NSMC, Auckland, New Zealand
Monday
– Friday 8am-5pm
Phone: 0800 232 633
Website: www.goldair.co.nz
A.
Power Switch
B.
Control Panel
C.
Screw Bolt Cap
D.
Heater Body
E.
Temperature Sensor
F.
Digital Temperature Display
CAUTION
The Heater generates heat during use. Proper
precautions must be taken to prevent the risk of
burns, scalds, fires or other damage to persons.
WARNING Keep all objects at least 1 metre
from the front of the Panel heater.
Содержание Ecosave GECO203
Страница 1: ...GECO203 ...