Pinpointing targets
: (Fig. 2)
Step back, then go forward slowly with a back &
forth coil motion toward the centre of gap. Once
the edge of the coil gets to the target, the trans-
ducer will respond. Now just dig!
Setting Ground Balance
: (with no sound)
The simplest way is to run the detector on TRACK-
ING, it will automatically cancel the affects of ground
mineralisation and adjust the ground balance setting
when the ground changes.
The change in balance is displayed by a steady
vibration from the haptic transducer. To adjust
and reset just pump your coil up and down 10cm
off the ground until the vibration stops.
Passing the coil over a loud target will overload
the machine as well, a steady vibration will be
produced. Use the same procedure as above.
Only use FIXED when you have a definite target.
Do not keep swinging the coil over the target in
TRACKING you may end up ground balancing out
the target.
9
Remember to always fill in
your holes
Fig. 1
Fig. 2
