2410E and 2411E
MODEL # 2410E AND 2411E
6
CONTROLS AND THEIR FUNCTION
HEAT/MOTOR SWITCH
This rocker switch in the “ON” position energizes the heating elements in the bottom of the kettle, and also
operates the motor for 15 seconds out of every minute.
MOTOR ONLY SWITCH
With this rocker switch in the “ON” position, the agitator motor will run continuously.
Note:
The main function of this switch is for mixing the product/popcorn at the end of the cooking
cycle with the kettle in the tilt position. It is also used for “cleaning mode”.
HEAT CONTROL
The machine comes from the factory preset at 280°F. If more or less heat is required, remove the silver hole
plug or cover plate, located on the front panel of the control box. This will allow you to access the heat
control adjustment potentiometer. Turn the potentiometer clockwise to increase the temperature, and
counter-clockwise to decrease.
To calibrate the heat control for corn treat, Fill the mixing bowl with a one inch depth of corn oil. Use an
accurate thermometer to measure the temperature of the oil in the mixing bowl. Turn the motor on to stir the
oil while it heats. When the oil reaches 280
F slowly turn the potentiometer counter clockwise until the
buzzer sounds. If the buzzer sounds before the temperature reaches 280
F, slowly turn the potentiometer
clockwise until the buzzer stops and continue to turn an additional 1/8 of turn.
Note:
The sound of the buzzer always signals temperature cut-off.
