Gold Medal 2001EX, Инструкция по эксплуатации

Страница: 5 / 36

Citation, Whiz Bang & Pop-a-Lot
A
LL
E
XPORT
M
ODELS 3
OPERATING INSTRUCTIONS
CONTROLS AND THEIR FUNCTIONS
LIGHT SWITCH
Flipping the lever of this switch to the "ON" position lights the bulbs in the popper dome
and the heat lamp in the case. (Heat lamp only on Antique Citation).
KETTLE MOTOR AND EXHAUST SWITCH
Flipping the lever of this switch to the "ON" position starts the agitator in the kettle and the
exhaust blower in the popper dome. The purpose of this agitator is to keep the raw kernels
on the bottom of the kettle and to prevent the popped corn from jamming.
WARMER SWITCH
Flipping the lever of this switch to the "ON" position energizes a blower-warmer system in
the Deluxe Citation, Citation and Deluxe Whiz Bang. On the Whiz Bang, Antique Citation
and Pop-a-Lot, this switch energizes two strip heaters on the underside of the corn pan.
These systems will freshen any pre-popped corn you may have left over, as well as keep
freshly popped corn warm and fresh.
"KETTLE HEAT" SWITCH
Moving the lever of this switch to the "ON" position energizes the heating elements or
element on the bottom of the kettle. When this switch is in the "ON" position, the red pilot
light next to it will be "ON".
NOTE
The following controls are only on the Antique Citation and Deluxe Citation poppers
equipped with a bucket seasoning pump.
"OIL SYSTEM MASTER" SWITCH
(Deluxe Antique Citations only)
Moving the lever of this switch to the "ON" position energizes the electrical circuit of
the bucket seasoning pump. It also supplies the heat element of the pump with 40
watts of electrical power. This "LOW HEAT" will usually keep the oil liquid at aver-
age room temperatures. When this switch is in the "ON" position, the red pilot light
above it will be "ON".
"OIL PUMP" BUTTON
After the oil has melted, pressing the red "OIL PUMP" button for a few seconds
until the pilot light comes "ON", will start an automatic pumping cycle, which deliv-
ers the proper amount of oil to the kettle. The oil pump pilot light will remain on
while the automatic pumping cycle takes place.