Gold Medal 2001EX, Инструкция по эксплуатации

Страница: 3 / 36

Citation, Whiz Bang & Pop-a-Lot
A
LL
E
XPORT
M
ODELS 1
Machine Name
Electrical Requirements
Wattage Size Current
Pop-A-Lot 1800 Watts 15 Amp
Whiz Bang 2400 Watts 20 Amp
Deluxe Whiz Bang 2800 Watts 30 Amp
Citation 2900 Watts 30 Amp
Deluxe Citation 3300 Watts 30 Amp
Antique Citation w/ Pump 3300 Watts w/ Pump 30 Amp w/ Pump
INSTALLATION INSTRUCTIONS
This Instruction Manual and parts list will cover all poppers listed on the front cover as these are
so similar in construction and operation.
There is a common parts list beginning on page xx. When using this parts list, refer to the column
which lists your machine and obtain all your part numbers from this column. If your machine serial
number does not agree with those given with the parts list, you must refer to the previous instruc-
tion manual. This manual covers machines manufactured after December 1, 1974 ONLY.
CHECKING SHIPMENT
Your new popper is completely assembled, ready to operate. Remove the corrugated carton
from the machine. Check thoroughly for any damage which may have occurred in transit.
Claims should be filed immmediately with the transportation company.
Remove cardboard packing from the kettle assembly and bottom tray. Remove tape from gear
on the agitator shaft and gear on the drive motor. Remove tape from base socket of heat lamp
and bottom corn pan. Remove all other tape and stickers now, they get harder to remove with
each passing day.
ELECTRICAL REQUIREMENTS
Standard voltages for all the popcorn machines covered by this manual is 120 volt, 60 cycle,
single phase, A.C. current. Your new popper is furnished with the proper attachment plug for
carrying the current, and this plug should always be used.
A wall receptacle and cover plate is shipped with each machine requiring 30 Amps. This
receptacle will accept the attachment plug on the popper and must be used. For your own
safety, have a qualified electrician wire this wall receptacle, and instruct him to follow the
diagram shown on page 4.
Amperage and wattage requirements for each machine are shown below. Your electrician
must furnish sufficient current for proper operation of your machine. We recommend each
popper be fused on a line by itself.
FLOOR MODELS ONLY
On floor model machines, the base is shipped in a separate carton. Unpack the base and
remove all packing material and tape. Remove the old maid pan from the popper. Untape the
lead-in cord and make sure it will hang free when the popper is lifted.
Lift the popper and set it on the base, making sure the popper lead-in cord is dangling inside
the base before lowering the popper into place. Run the lead-in cord through the hole in the