16 oz. Pop & Self-Serve
Model No. 1617E
Page 6
gmpopcorn.com
Setup
This unit has been tested at the factory.
1.
Remove all packaging and tape prior to operation.
2.
Place the unit on a sturdy, level surface.
3.
The Popper blower vents out the top of unit, allow adequate clearance for airflow.
Sufficient clearance is also needed on side of the popper with power supply cord
routed from the base.
4.
The door knobs are shipped facing the inside of the machine. Re-adjust knobs to face
the outside of the machine.
5.
Make sure kettle lead-in cord is securely plugged into the unit and the locking ring is
fully twisted clockwise onto the kettle receptacle (see image below). (Turn lock ring
counter-clockwise to remove.)
6.
The main power cord is located on cabinet base (see image below). A wall receptacle
is provided (reference the Electrical Requirements section).
Units with oil ready features have a secondary, special power cord provided for
powering the oil dispense unit (available for purchase separately). These units are
equipped with an aluminum oil line for connecting the oil dispense unit. (Reference
the Instruction Manual for the oil dispense unit to connect it to the popper.)
7.
After setup, unit should be cleaned prior to use (see Care and Cleaning section).
Images shown for general reference only.
Make sure kettle lead is plugged
in and lock ring is twisted to
lock onto the kettle receptacle.
Power Cord
Power Cord Socket
(for 6 Prong Plug on
Oil Dispense Unit)
Aluminum Oil Line
(for connecting oil
to popper)