Caramatic
ProTwo
1
8
part no. 02 592 99
CONNECTIONS
Inlet,
Trading name and dimensions
acc. to standard
Installation notes
Male thread connections
•
G.13
= thread M 20 x 1.5
Tightening torque:
Coupling nut =
4 to 5 Nm
Outlet,
Trading name and dimensions
acc. to standard
Installation notes
Compression fitting RVS
•
H.9
= compr. fit 8 or compr. fit 10
Alternatively, other connections can be obtained from the manufacturer on request.
Connections could become leaky, if they are contaminated or corrupted
Therefore, the connections must regularly be checked for leak-tightness.
Swap the product where appropriate.
Keep all connections free from contamination, even small amounts of dirt can cause
connections to leak.
ASSEMBLY
Before assembly, check that the product is complete and has not suffered any damage during
transport.
ASSEMBLY must be carried out by a specialised company.
See USER QUALIFICATION!
The specialised company and the operator must observe, comply with and understand all of
the following instructions in this assembly and operating manual. For the system to function
as intended, it must be installed professionally in compliance with the technical rules
applicable to the planning, construction and operation of the entire system.
Consider installation location and installation position (see instructions on INTENDED USE).
Risk of injuries due to blown-out metal chips!
Metal chips may cause eye injuries.
Wear safety goggles!
Malfunctions caused by residues!
Proper functioning is not guaranteed.
Visually check that there are no metal chips or other residues in the connections!
It is important that metal chips or other residues are blown out!
Install with suitable tools, if required.
Regarding screw connections, use a second spanner to brace against the connection nozzle.
Do not use unsuitable tools, such as pliers.
Product damaged through incorrect installation direction
Proper functioning is not guaranteed.
Observe the installation direction (marked on the product with an arrow ).
