gofanco HDExt24-HD20, Руководство пользователя

Страница: 13 / 28

13
Controlling the Display Device(s) using IR All In Port
Allows remote controlling of all of the display devices
simultaneously.
1. Connect an IR Receiver Cable to the IR All In port of
the Splitter/Extender.
2. Connect an IR Emitter Cable to the IR Out port on
each CAT 6/7 Receiver.
3. Point the IR Emitter Cable's IR eye in line with the
display's IR window.
Figure 7: Display Device IR Control Connection Diagram
Note:
The IR All In will relay the received IR signal to all the
CAT 6/7 outputs whereas the IR IN connectors associated
with each CAT 6/7 output will only relay the IR signal to
its respective CAT 6/7 Receiver. The IR All In can also be
connected to the IR Loop Out of another Splitter/Extender
when two or more units (up to a maximum of five) are
connected in a cascade mode while using only a single IR
detector at the start of the cascade connection.
The IR Out connector will output the IR signals received
from any of the CAT 6/7 Receivers, so as to allow control
of a source from any of the remote CAT 6/7 Receivers.