GOEBEL GO-100, Руководство пользователя

Страница: 10 / 24

2. Operating Instructions
2.1 Starting instructions
Install battery on tool, check battery power on power indication:
4 LED lights on, power 95% ±5%;
3 LED lights on, power 75% ±5%;
2 LED lights on, power 50% ±5%;
1 LED light on, power 25% ±5% remaining,
charging battery is recommended.
During tool operation, press the button on power indication and the remai-
ning power is shown.
- Choose correct nose piece and it onto the tool
(see 1.2)
- Ensure that vent holes on the tool body are not covered or
obstructed
- Ensure that the mandrel collector is installed onto the tool
2.2 Operating instruction
- Insert the rivet mandrel fully into the nose piece, install it onto the
work piece, start the operation by depressing the trigger.
- After the rivet is set, release the trigger and the jaw assembly of the
tool returns to the start position automatically.
- Eject the rest mandrel by tilting to the rear into the mandrel
collector, or to the front through the nose piece.
- The tool is equipped with overload protection.
In the event of an overload, the operation will be stopped and the
warning light shows. Release the trigger and the jaw assembly will
return to the start position.
10