GOEBEL Air Power 3, Руководство по эксплуатации

Страница: 13 / 32

1. GENERAL SAFETY INSTRUCTIONS AND PRINCIPLES
ATTENTION! Read all instructions and principles carefully. Every person installing, operating
or maintaining the tool must be first thoroughly acquainted with this operations manual and is
obliged to adhere to the following safety instructions and principles:
• The tool must not be used for other purposes than those for which it was designed.
• The tool must not be used in a different manner than that recommended by the manufacturer
• Any alterations of the tool, its accessories or spare parts remain in sole responsibility of
the customer. After agreement the manufacturer provide technical support in designing
and making additional alterations.
• The tool must be kept in top condition and regularly tested for damage and proper opera-
tion. The tool must be repaired only by an authorized technician or by a person trained by
the manufacturer or supplier. Should you have any demand for training, please contact your
sales agent.
• The tool must always be operated in accordance with respective sanitary and safety
regulations.
• All queries regarding proper and safe operation of the tool should be addressed to your
sales agent.
• Safety principles that must be adhered to in connection with operation of this tool must be
known to all workers who operate the tool.
• When handling the tool take extra care to avoid unwanted activation and possible injury.
• The tool must be during any kind of maintenance or repair (does not apply to replacing
nose-pieces and emptying the mandrel container) disconnected from the source of
compressed air.
• Before operating the tool always take up firm posture and steady position.
• It is necessary to prevent break-away shanks endangering safe operation of the tool.
• Never aim with the tool at another person.
• Always check that the vent holes are not blocked or covered and that the supply hose are
in good condition.
• Working pressure must not exceed 0,7 MPa.
• Oxygen or other flammable gasses from pressure cylinders must not serve as a driving
agent.
• When operating the tool it is recommended to use safety glasses and utility gloves.
• If the continuous cycle of riveting exceeds 8 hours per day, it is recommended that the
operators use ear protectors.
• When working with the tool the operator must not have loose parts of wear as e.g. a tie, long
hair, jewellery etc. to avoid getting caught by the tool.
• Same safety instructions apply for persons standing close to the tool.
• Avoid unnecessary contact with the hydraulic fluid to prevent possible allergy reaction
of the skin.
• The tool is not designed for outdoor and explosive environment.
• After the service life, discard the tool according to the Disposal Act no. 185/01 Coll.
AIR POWER 3 ENGLISH
13