Digital Video Recorder: User Manual
27
[
PPPOE setup
]: Input the user name and password that ISP (Internet service provider) provides. After saving it reboot up your system. Then the DVR
will build a network connection based on PPPOE. The IP address will change into dynamic IP address above operation is well do ne.
Operation: After PPPOE dialing successfully look up the IP address in the [IP address] and obtain the current IP address. Then use this IP address to visit
the DVR through user port.
[
NTP setup
]: The NTP server must be installed in the PC.
Host computer IP:
Input the IP address installed NTP server.
Port:
Default 123. You can set the port according to NTP server.
Time zone:
London GMT+0, Berlin GMT+1, Cairo GMT+2, Moscow GMT+3, New Delhi GMT+5, Bangkok GMT+7, Hong Kong Beijing GMT+8,
Tokyo GMT+9, Sydney GMT+10, Hawaii GMT-10, Alaska GMT-9, Pacific time GMT-8, American mountain time GMT-7, American mid time GMT-6,
American eastern time GMT-5, Atlantic time GMT-4, Brazil GMT-3, Atlantic mid time GMT-2.
Update cycle:
The same with the NTP server check interval. Default: 10 minutes.
Picture 4.13 DNS setup Picture 4.14 Mobile Monitor Setup Picture 4.15 Output Mode
[DDNS
] It is the abbreviation of dynamic domain name server.
Local domain name:
Provide the domain name registered by DDNS.
User name:
Provide the account registered by DDNS.
Password:
Provide the password registered by DDNS. When the DDNS is successfully configured and start, you can connect the domain name in the IP
address.
Note: The DNS must be configured in the network setup.
[Mobile Monitor Setup]
To visit the device by mobile, please make a router mapping of this port and use CMS to monitor and operate it by protocol.
[Enable]
Select it to make sure abnormal function workable.
[Port]
It‟s a port of mobile monitoring which you need to make a router mapping of if want to visit it by mobile.
