15
04
01
07
02
08
19
14
09
10
03
05
06
11
12
16
17
13
18
Body
NAMES OF PARTS
01. AC Power Socket
02. Sync Cord Jack
03. Power Switch
04. Modeling Lamp Output Controller
05. Flash Output Controller
06. Modeling Lamp Button
07. Sound Button
08. Slave Model Button
09. Test Button
10. Digital Display
11. Modeling Lamp Indicator
12. Buzz Indicator
13. Slave Triggering Indicator
14. Test Indicator Lamp
15. Light Sensor
16. Fuse
17. Mounting Bracket
18. Umbrella Input
19. Direction Adjusting Handle
20. Wireless control port
1.
Power Cord
2.
Lamp Cover
3.
Glass Protection Cover
4.
Modeling Lamp
5. Instruction Manual
Accessories
20
- 10 -
- 09 -
To prevent damage to the product or injury to you or to others, read the
following warnings in their entirety before using this product. Keep these
Warnings where users can read them for ready reference.
Do not disassemble or modify. Should the product break down, send the
defective back to the authorized service center for inspection and maintenance.
Keep dry. Do not handle with wet hands, immerse in water, or expose to rain.
Keep out of reach of children.
Please put the device in a ventilation environment and keep the parts of lighting
and heat dissipation holes are unobstructed. Do not use in flammable
environment.
As this product adopts make and break device, please keep it easy to be used.
No touching the heating parts of this product.
Please turn off the power and wear insulated gloves before installing and
connecting accessories. When replacing the tube or modeling lamp, please
make sure that the tube is cool and wear insulated gloves to prevent burns.
Do not flash directly towards naked eyes (especially those of babies), otherwise
it may lead to visual impairment.
Disconnect from the power supply when it will not be used for an extended
period.
CAUTION
After 30 continuous flashes at full power, the flash should be cooled down for
about 3 minutes. Overheating will occur if it is used continuously without cooling
down.
Do not keep using the modeling lamp for a long time; otherwise flammable
accessories attaching to flash head, e.g. softbox will get burnt. A 10-minute time
is recommended in this case. After 10 minutes, cool it down for 1 minute.
When using a snoot, do not keep the modeling lamp on for a long time or fire too
frequently (not over six times for one minute). Overheating will result in damages
for strobe housing and/or studio light.
Avoid sudden impacts as this can damage the flash tube and/or modeling lamp.
Warning
FUSE: 5A
AC220V-240V~50Hz
4
3
2
1
