Separately sold accessories
The product can be used in combination with the following accessories sold separately,
so as to achieve best photography effects:
Power Inverter, Softbox, Photographic Umbrella, Light Stand, Barndoor, Snoot, etc.
OPERATIONS
Flash Preparation
1. Take down the lamp
cover. Install the modeling
lamp and put on the glass
protection cover and the
standard reflector
(
optional
accessory).
(To uninstall the standard
reflector, press the blue
release button on the flash
head and turn the standard
reflector counter-clockwise to take it out, as illustrated in the picture.)
2. Attach the flash unit on an appropriate light stand. Adjust the mounting bracket (17)
for a good angle and make sure it is tightened and fixed. Use the direction adjusting
handle (19) to adjust the flash to a desired direction. Umbrella input (18) is for different
photographic umbrellas to put in.
Power Connection
Use the power cord to connect the flash to an AC power source and turn on the power
switch (3). The lamp on the power switch turns on, indicating it’s connected.
Modeling Lamp
Modeling lamp button (6) controls the modeling lamp status: Modeling lamp indicator
(11) is on, indicating the modeling lamp is on; Modeling lamp indicator (11) is off,
indicating the modeling lamp is turned off. Modeling lamp output controller (4) can be
used to adjust the modeling lamp power output. Modeling lamp will be off automatically
after lighting for 2 hours, in case overheating occurs when user is not nearby to turn it
off.
When there is flammable accessory on the flash unit, do not keep the
modeling lamp on for a long time. It is recommended to cool it down for one
minute after 10 minutes' working.
Power Output Control
Flash output controller (5) decides different power output, satisfying light requirements
in different environment. The power is adjustable from 5.0 to 8.0 which will be
accordingly shown on the digital display (10). "OF" on the display indicates that the
flash triggering function is shut down. It can automatically discharge power when the
flash output is adjusted from high to low.
Test Button
To fire the flash without taking a picture, press the test button (9). It can also help
adjust the flash brightness when using together with the flash output controller (5).
Sync Triggering
The sync cord jack (2) is a Φ6.35mm
plug. Insert a trigger plug here and the
flash will be fired synchronously with
the camera shutter.
Slave Trigger Model
Three slave triggering models are
available and can be set by pressing
Slave Model Button (8).
◆
No optical control: The slave triggering indicator (13) is off, indicating the slave
triggering function is shut down.
◆
One fire model: The slave triggering indicator (13) glows blue, indicating the flash
will fire synchronously on one external flash. In this model, the flash can function as an
auxiliary lamp, offering various effects of light and shadow.
◆
Anti-preflash model: The slave triggering indicator (13) glows red, indicating the
flash will receive two external flashes within 2 seconds and will fire synchronously on
the second flash. In this model, the flash can function as an auxiliary lamp, applicable
to TTL system. With this anti-preflash function, synchronization is supported with
cameras having a one-preflash firing system
Buzz Function
The sound button (7) is used to decide whether there is sound reminder for ready flash
after recharging. When the buzz indicator (12) is on, the buzz function is working; if it is
off, the buzz function is shut down. A “BI” sound will be heard when it’s fully charged.
Memory Function
The device is equipped with memory function for the panel setting. It will help
remember the panel setting 3 seconds after you set it. When starting up the flash next
time, the panel setting will be the same as that before powering it off.
- 12 -
- 11 -
