Godin 364120, Инструкция по эксплуатации

Страница: 4 / 11

Page | 4
GENERAL PRINCIPLES OF CONNECTION FOR REAR AND TOP FLUE OUTLETS (WHERE POSSIBLE)
Instructions for the installer:

Always respect the rules in force of the country where the unit is being installed.

Make sure the chimney conduit is of good quality. The quality of the chimney conduit will determine the end
result.

It is essential to check that the room in which the appliance is installed is sufficiently ventilated to provide
adequate air supply.

The majority of problems experienced during the operation of the unit are related to an adjustment in the
specified chimney conduit. We cannot emphasize this point enough.

A comparison cannot be made with previous unit’s results where the air supply is different.

An efficient chimney must be built with materials, which have poor heating conductive capacity.

The minimum cross section of the chimney for a fireplace working with the doors shut is 2.5dm2 (39sq.in), which
corresponds to 180mm (7.09in) diameter (according to French regulations). A flue pipe conduit of 150mm can
be used and it is recommended that the height of the flue is not less than 5 metres.

In no case can this section be reduced, otherwise its flow capacity shall be reduced, and it would cause smoke to
spread into the room when the fireplace’s door is open.

The chimney must be perfectly airtight.

The chimney must only vent one fireplace.

It must suitably emerge into free air at least 0.40m (15 in.) above the rooftop or any other obstacle situated
within a distance of 8 meters (27 feet) from the chimney.

The height of the chimney deviation must be very open angled.