Goddess Bibione 1, Инструкция по эксплуатации

Страница: 9 / 16

ENG
ENG - 35
OPERATION
1) Precautions
a) Check all the circuitry and the plug meet all requirements.
b) Set the temperature and time to a comfortable level, normally, 60 minutes at
50-65ºC (122ºF-140ºF)
Note: If ambient temperature is lower than 18.3ºC (65ºF), please set the temperature at
about 122ºF (50ºC); and if ambient temperature is higher than 18.3ºC (65ºF), please set
the temperature at about 65ºC (140ºF).
c) Drink a cup of water before the sauna session.
d) After 2 hours of continuous use, shut the sauna down for one hour.
e) To avoid burns, do not touch the heating element.
2) Operation
a) plug the sauna into a wall outlet (220V-240 Volt) which is stated in nameplate.
Do not share the outlet with any other appliances.
Switch on the main switch at the ceiling of the sauna room and then activate the sauna
through the ON/OFF switch on the control panel.
Sauna should be unplugged when not in use.
b) Press the ‘temperature’ button ▲,▼ to increase or decrease the temperature. Every
time the “▲“ button is pushed. If pressed for three seconds, the setting will increase
quickly. Decrease the temperature in the same manner by pressing the “▼“ button.
After the sauna reaches the desired temperature, the “heat“ light turns off.
c) Press the ‘time’ button ▲,▼ to set the using time. The same operation as b.
When the display time is “05”,the buzzer will clew 1 minute.
d) Press the ‘light’ button to turn the interior light on and off.
e) After your sauna session, turn off, and unplug the power cable.
f ) To set the time press the “function“ button until the ‘time” button blinks. Press the “+“ and
“-“ buttons to set the timer from 5 to 60 minutes. If pressed for three seconds, the timer
will increase quickly. When the display reads “05“, the timer will buzzes then the
machine will shut off automatically after 5 minutes. To extend the sauna session, reset
the timer again.
g) The Fahrenheit and Centigrade display can be switched: press the temperature button “+“
and “-“ at the meantime, then press the button of „light“ to switch
h) If you want to activate (or deactivate) the ionizer, you can do it any time during the sauna
process by switching the ON (OFF) button on the ionizer.