Goalsetter Systems Junior Hoop, Инструкция по установке и эксплуатации

Страница: 12 / 16

J Ju un niio orr H Ho oo op p IIn ntte errn na all J Ja ac ck k S Sy ys stte em m IIn ns sttrru uc cttiio on ns s
1122 w ww ww w..g go oaallsseetttteerrssyysstteem mss..cco om m 880000..336622..G GO OA ALL ((44662255))
R RIIM M A AT TT TA AC CH HM ME EN NT T
44
11
22
33
S Stteep p 11::
Remove any cardboard edge protectors
and protective sheeting from backboard.
N NO OT TE E::
Four steel shouldered bushings
11
are
factory installed. If loose, make sure to have them
seated properly when tightening rim bolts. If
missing, contact Goalsetter or dealer to get
replacements.
D DO O N NO OT T iinnssttaallll rriim m w wiitthho ouutt
b buusshhiinng gss..
IIM MP PO OR RT TA AN NT T::
Correct sequence of hardware
installation MUST be followed during assembly.
S Stteep p 22::
Loosely attach rim
44
to backboard
through top mounting holes
22
with two 3/8" x 2"
bolts (#13 in parts list), four flat washers, two lock
washers and two nuts. Snug tighten hardware – a
9/16" open-end wrench may be necessary.
H Haarrd dw waarree S Seeq quueennccee:: Bolt passes through flat washer - rim
backplate - backboard bushing - backboard mounting plate -
flat washer - lock washer - nut.
S Stteep p 33::
Repeat procedure outlined in Step 2 for
lower rim mounting holes
33
.
S Stteep p 44::
Level rim side to side and then fully tighten
hardware.
S Stteep p 55::
Attach net to rim.
G GO OA ALL A ALLIIG GN NM ME EN NT T
S Stteep p 11::
Check goal assembly with a level and inspect visually to
determine if it is parallel and plumb to playing surface.
S Stteep p 22::
If adjustments are necessary, slightly loosen bolts to rotate goal
or place shims between pole plate and ground anchor plate.