Goalsetter Systems Junior Hoop, Инструкция по установке и эксплуатации

Страница: 10 / 16

J Ju un niio orr H Ho oo op p IIn ntte errn na all J Ja ac ck k S Sy ys stte em m IIn ns sttrru uc cttiio on ns s
1100 w ww ww w..g go oaallsseetttteerrssyysstteem mss..cco om m 880000..336622..G GO OA ALL ((44662255))
P PO OLLE E A AS SS SE EM MB BLLY Y
S Stteep p 11::
Remove five plastic plugs from threaded
holes in ground anchor.
N NO OT TE E::
Use protective padding to protect pole finish.
S Stteep p 22::
Unpack pole and jack.
N NO OT TE E
: On the all models, the jack assembly is
already installed in the pole.
S Stteep p 33::
Locate five 1/2" x 1-1/4" bolts
11
(#3 in
parts list). Prepare them for use by having lock
washer
22
slipped on as shown.
S Stteep p 44::
Fasten pole
33
to threaded ground anchor
plate
44
as follows:
•First, install and tighten three back bolts
55
with
lock washers.
•Then, install and tighten two front bolts 66 with
lock washers.
S Stteep p 55::
Fully tighten five bolts.
IIM MP PO OR RT TA AN NT T:: The bolts must pass all the way
through the ground anchor plate. If they are
recessed within the plate when fully tightened,
please contact Goalsetter Systems.
S Stteep p 66:: Pull jack assembly 77 out slightly, remove
packing and protective materials from end of jack
and reposition jack in pole.
S Stteep p 77::
Insert crank handle through access hole
and slide onto shaft.
N NO OT TE E:: If a permanent crank handle installation is
desired, refer to Permanent Crank Handle
Attachment.
S Stteep p 88::
Position lower extension arm
88
with clevis
99
toward pole offset. Align lower extension arm
pivot holes with lower holes 1100 in pole.
1122
1111
88
1100
99
77
11
22
Both Sides
33
44
66
55