GOALRILLA B3200W, Руководство пользователя

Страница: 6 / 17

ASSEMBLY INSTRUCTIONS (Day 5) GOALRILLA
TM
TOOLS REQUIRED FOR THE FOLLOWING STEPS
1 - 15/16" open end wrench
1 - 15/16” socket and ratchet (optional)
1 - 9/16” Deep Well Socket & Ratchet
1 - 3/4” Socket & Ratchet
1 - 3/4” Open end Wrench
1 - Phillips Screwdriver 1 - Level
1 - Tape Measure
1 - Rubber Mallet
1 - Set of Padded Saw horses
1 - Ladder
Figure 4
5
5
15
3
3
16
18
18
19
19
1
2
1.
2.
Attach Post Brackets (#44) to outside of brackets on back
of Post Assembly (#2). Secure with two Hex Head Bolts
(#46), four Wide Flat Head Washers (#26) and two
Locknuts (#33) in each Bracket (#44). See Figure 3 .
If not already pre-assembled, slide Plastic Actuator Sleeve
(#15) over Steel Actuator (#16) and place Actuator Cap (#13)
on top. Align holes in all 3 parts and slide Pivot Tube (#14)
through holes in Actuator Cap (#13) Plastic Actuator Sleeve (#15)
and Steel Actuator (#16) until equal amounts stick out through
both sides of actuator. See Figure 4 .
Figure 3
Figure 3
Figure 3
33
44
26
2
2
44
46
46
26
26
26
3.
NOTE: It may be necessary to use a rubber mallet
to tap in Pivot Tube.
4. If not already pre-assembled, insert Pole
Cap (#1) into top of Pole (#2). It may
be necessary to use a rubber mallet to
tap cap in. See Figure 4 .
Lay Pole (#2) on its side on two padded saw horses.
Secure Actuator (#16) to Pole (#2) using one bolt
(#19), split lockwasher (#18), washer (#3) and two
plastic washers (#5) to thread into each side of
Actuator. See Figure 4 . Tighten bolts tight.
14
13
6