5
5
15
3
3
16
18
18
19
19
1
2
Figure 4
3.
Lay Pole (#2) on its side on two padded saw horses. Secure
Actuator (#16) to Pole (#2) using one bolt (#19), split
lockwasher (#18), washer (#3) and two plastic washers (#5)
to thread into each side of Actuator. See Figure 4. Tighten
bolts tight.
5.
Attach lower arm (#11) to Pole (#2), as shown in Figure 5,
using a bolt (#8), two flat washers (#3), four plastic washers
(#5) and hex nut (#4).
Note: make sure "Goalrilla" lettering is right side up.
DO NOT tighten bolt (#8) at this time. See Figure 5.
.
Figure 5
8
3
5
5
5
3
4
11
2
ASSEMBLY INSTRUCTIONS (Day 5)
GOALRILLA
TM
TOOL REQUIRED FOR THE FOLLOWING STEPS
1 - 15/16" open end wrench
1 - 15/16” socket and ratchet (optional)
1 - Level
1 - Tape Measure
1 - Rubber Mallet
1 - Set of Padded Saw horses
1 - 9/16” Deep Well Socket & Ratchet
1 - 3/4” Socket & Ratchet
1 - 3/4” Open end Wrench
1 - Phillips Screwdriver
1 - Ladder
NOTE: It is important for the installer to understand
the necessity of the Plastic Washers (#5) provided.
These washers adequately space painted parts at all
pivot points. Neglecting the use of these washers will
result in rusted parts.
NOTE: All board arms are made of rectangular
tubing. Tightening hardware too tight may
damage tubing and make adjustment of system
difficult.
NOTE: It may be necessary to use a rubber mallet
to tap in Pivot Tube.
Figure 3
Figure 3
Figure 3
33
44
45
2
2
44
46
46
45
1.
2.
Attach Post Brackets (#44) to outside of brackets on back of Post
Assembly (#2). Secure with two Hex Head Bolts (#46), four
Wide Flat Head Washers (#45) and two Locknuts (#33)
in each
Bracket
(#44). See Figure 3.
If not already pre-assembled, slide Plastic Actuator Sleeve
(#15) over Steel Actuator (#16) and place Actuator Cap (#13)
on top.
Align holes in all 3 parts
and slide Pivot Tube (#14)
through holes in Actuator Cap (#13) Plastic Actuator Sleeve
(#15) and Steel Actuator (#16) until equal amounts stick out
through both sides of actuator. See
Figure 4
.
45
45
4.
If not already pre-assembled, insert Pole Cap (#1) into top
of Pole (#2). It may be necessary to use a rubber mallet to
tap cap in. See
Figure 4
.
6
Содержание B3100W
Страница 2: ...2...
