17.
18.
Place a level across rim assembly and adjust rim until it is level.
Finish tightening the four nuts.
Figure 10
Figure 11
19.
Attach Rim Cover Plate (#31) using four screws (#32). See
Figure 11.
20.
NEVER USE RIM WITH COVERPLATE REMOVED!
NEVER USE RIM WITH COVERPLATE REMOVED!
Check all nuts and bolts to make sure everything is tightened
properly.
DO NOT
over tighten pivot points, snug is tight
enough.
Pre-Installed
23
20
3
5
22
11
22
5
3
20
47
3 5
22
5
3 20
6
22
5
20 3
5
3
47
47
3
5
F
H
E
G
D
C
C
D
47
3
5
B
A
H
G
B
A
E
F
ATTACHING BACKBOARD TO BOARD ARMS
REQUIRES AT LEAST FOUR CAPABLE ADULTS.
15.
With at least three capable people, raise the backboard assembly
up and have the fourth attach Lower Board Arms to lower
mounting holes on backboard using two bolts (#20), two step
bushings (#22), (shipped already installed), four plastic
washers (#5), four flat washers (#3) and two thin
locknuts (#47). See Figure 10.
Note: DO NOT over tighten these bolts.
This is a pivot point. Snug is tight enough.
16.
Note: DO NOT over tighten these bolts.
This is a pivot point. Snug is tight enough.
Attach Upper Board Arms to upper mounting
holes on backboard using two bolts (#20), two
step bushings (#22) (if not pre-installed), four
plastic washers (#5), four flat washers (#3) and
two thin locknuts (#47). See Figure 10
Remove protective backboard covering and mount Goal
Assembly (#28) to Spacer Plate (#27 pre-installed) and
Backboard, as shown in Figure 11, using four bolts (#29), four
washers (#26), and four locknuts (#33). Tighten fasteners
finger tight, but leave them loose enough to level rim.
Note
: Be sure to
install board arms
to the OUTSIDE of
tube as shown.
10
Содержание B3100W
Страница 2: ...2...
