Original instruction manual
28
ASSEMBLY (FIG. 2)
Remove the heater and all the accessories from the carton.
1. Turn the heater upside down and place it on a soft surface (carpet or blanket) to prevent
damages.
2. Position the wheel axis between the first two and the last two fins.
3. Attach them to the heater by using the U-bolts and supplied wing nuts.
4. Fasten the wing nuts.
5. Bring the appliance in an upright position and let it stand for at least 1 minute before connecting it
to a power outlet.
FIG. 2
OPERATION
Place the heater on a flat surface and keep a safety distance of at least 90 cm (walls, furniture,
curtains, plants and other combustible objects). Make sure your power supply corresponds to the
power which is indicated on the rating label beforehand. Ensure that the Thermostat and Power
Control Switch are set to “0” before connecting the unit to the mains supply.
1. The Power Control Switch:
With the this switch you can select your desired heating power:
O
= OFF
I
= Low Heating Power (600 W)
II
= Medium Heating Power (900 W)
III = High Heating Power (1500 W)
Remark: “I” is recommended for a small room. If this isn’t sufficient for you then switch to “II” or
“III”
.
2. The Thermostat Switch
The from you desired room temperature will be set with the Thermostat Switch. Turn the switch
clockwise to increase the temperature or anti-clockwise to decrease the temperature.
Remark:
To set your desired room temperature and keeping it constant, please proceed as following:
Set the thermostat switch to the highest temperature (clockwise) whereby the operating light
switches on. After your room reached the desired temperature, you slowly turn the thermostat knob
anti-clockwise till to the point the heater switches off. The automatic temperature regulator will keep
now the set room temperature by switching the heater on and off.