Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety information
Please refer to the booklet included in delivery for
the safety instructions.
2. Layout:
1 Lamp
2 Bit chuck
3 Changeover switch for forward/reverse / ON/OFF
switch
4 Charging connection
5 ON/OFF switch for lamp
6 Battery charger
7 Locking button
8 Control lamp for charging
9 Charging cable
3. Proper use
The cordless screwdriver is designed for tightening
and undoing screws.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Important information
Be sure to read the following information before you
use your cordless screwdriver for the first time:
1. Charge the battery pack with the charger
supplied. An empty battery pack requires a
charging period of approximately 3-5 hours.
2. Only ever use sharp drill bits and screwdriver bits
which are suitable for the purpose and in faultless
condition.
3. Always check for concealed electric cables and
gas and water pipes when drilling and screwing in
walls.
5. Starting up
Charging the NC battery pack
1. Check that your mains voltage is the same as that
marked on the rating plate of the battery charger.
Plug the battery charger in the socket-outlet and
connect the charging cable to the charging
connection.
2. The red LED (8) will come on to indicate that the
battery pack is being charged.
3. An empty battery pack requires a maximum
charging period of 5 hours. The temperature of the
battery pack may rise slightly during the charging
operation. This is normal.
Important! The charger does not switch off
automatically when the battery pack is fully
charged!
Disconnect the charging cable from the
screwdriver after charging.
If the battery pack fails to become charged, please
check
whether there is voltage at the socket-outlet
whether there is proper contact at the charging
contacts on the charger.
If the battery still fails to become charged, please
return
the charger
the screwdriver
to our Customer Service Department.
Timely recharging of the Ni-Cd battery pack is
recommended in the interest of long battery life.
Recharging is always necessary when you notice
that the power of the battery-powered
drill/screwdriver is decreasing.
Never allow the battery pack to discharge
completely. This will result in damage to the Ni-Cd
battery pack!
6
GB
Anleitung AS 4_8 V_SPK7:_ 03.05.2007 13:26 Uhr Seite 6
