18
START LAMINATING
1. The safety shield and feed table
must be in the normal operating
position.
2. Select a job mode (
) and
ensure the proper speed and
temperatures are set. Refer to
the section entitled
SPEED/
TEMPERATURE GUIDE.
3. Set the roller handle to one of
the laminating positions.
4. Press the PRESS/ RELEASE (
)
button. The main rollers gap.
5. Press the RUN (
) button.
6. Press the PRESS/ RELEASE
(
) button. The main rollers
close.
7. Adjust unwind and rewind
tensions as necessary.
8. Align the leading edge of the
item square to the heat roller nip
(Figure 30).
9. With both hands and an outward
force push the image slower
than the speed of the rollers into
the nip of the heat rollers (Figure
31).
CAUTION: Avoid forcing the
image into the main roller nip
as this action will cause the
corners of the leading edge to
buckle and create a wave.
Fig. 30
Fig. 31
