12
O. REWIND SHAFT: (Figure 18) The
rewind shaft holds the rewind tube
on the machine.
P. REWIND TUBE: (Figure 18) The
two rewind tubes located at the
front of the machine are used to
rewind release liners. The one
located at the rear of the machine
is used to rewind the finished
product.
Q. REWIND ADAPTORS: (Figure
18) Hold and lock the rewind tube
on the rewind shafts to prevent
side to side shifting.
R. REAR TABLE: (Figure 19)
Provides a working surface when
operating the machine from the
rear. This table may also be
lowered when webbing for roll to
roll applications.
To lower, slide the left and right
side rear table latches (1) to the
unlatched position and lower the
rear table.
S. REAR SLITTER: (Figure 19)
Used to cut the film web where it
exits the rear of the laminator.
To make a cut, push down on the
blade engage lever and slide to the
apposite side.
T. FILM WEB: Laminating film
loaded into the machine.
U. NIP POINT: The point at which
the top and bottom rollers come into
contact. The Nip Point of the heat
rollers is the place at which the
items for lamination are introduced
into the laminator.
V. FOOTSWITCH: (Figure 20) Used
to assist in webbing of the machine
and initial feeding of material.
W. PRINT UNWIND BASKET:
(Figure 20) Holds a rolled image.
Prevents the image from touching
the floor.
X. SEPARATOR BAR OPTION:
(Figure 18) Required if running
Micronext
® material.
To install, replace the rear slitter
with the separator bar.
Y. REWIND KIT OPTION: Enables
roll to roll webbing of material. This
kit must be installed by a qualified
G
MP
service representative.
Fig. 18
Fig. 19
Fig. 20
(P)
(O)
(Q)
(1)
(2)
(1)
(S)
(R)
(W)
(V)
