14
LOADING TOP THERMAL FILM
This procedure describes how to
load the upper roll of film onto the
laminator. Figure 23 uses poly-in
film and the upper rear unwind/
rewind position for illustration
purpose.
1. Turn the Power ON/OFF to on
(I). Set top heat temperature for
the film type you are using.
2. Ensure no brake tension is
applied to the film shaft.
3. Remove the safety shield and
pivot the feed table down.
4. Pull the top roll of film down
under the idler bar and allow to
drape over the top heat roller
(Figure 23).
5. Reference one of the loading
bottom material procedures.
LOADING TOP PSA FILM
This procedure describes how to
load the upper roll of film onto the
laminator. Figure 24 uses PSA film
and the upper rear unwind/ rewind
position for illustration purpose.
1. Turn the Power ON/OFF to on
(I). If the laminator is already
hot, turn POWER ON/OFF to the
off (O) position and allow the
unit to cool. Once cool, turn the
laminator back on.
2. Ensure no brake tension is
applied to the film shaft.
3. Remove the safety shield and
pivot the feed table down.
4. Set the roll of film in the rear
unwind/ rewind position and the
rewind tube in the front unwind/
rewind position.
5. Pull the top roll of film down
under the idler bar and up the
upper front rewind tube.
6. Place one piece of masking tape
in the center of the film and
secure to the rewind tube.
7. Make two full wraps around the
rewind tube, then carefully
score the laminate without
cutting the release liner.
8. Pull the laminate down allowing it
to drape over the upper main
roller.
9. Reference one of the loading
bottom material procedures.
Fig. 23
Fig. 24
