MAINTENANCE
Any work on mechanical parts and the electrical system must be carried out by fully qualified
personnel.
Under normal working conditions, E ironers require a minimum of maintenance. To ensure less friction on the
items during the ironing process and to keep the chromed surface of the ironing plate clean, it is advisable the
daily use of "G-SIL", a special product for roller ironing which replaces wax. Spray evenly onto the roller as it
rotates. Useful tip spray from under the feed-in wooden table with the ironing plate under pressure and slightly
heated (80-90°C). Use the spray as and when necessary.
Operations carried out by professionally qualified personnel
: make sure that the ironed is disconnected from the
mains before carrying out maintenance. The mechanical moving parts require weekly lubrication. The reduction
gears are self-lubricating and do not require maintenance.
The surface of the roller must be checked weekly to ensure that it is smooth and even along its whole length. Any
worn areas can be re-padded with steel wool or the external covering can be replaced.
ORIGINAL SPARE PARTS
The original spare parts are specially made to fulfil our requirements regarding their manufacture, correspondence
to the original components and materials used and are therefore ideal for our ironers.
To order spare parts, provide the following details:
1) the name of the machine - see data on the rathing plate -
2) the serial number - see data on the rathing plate -
3) the code of spare part - see spare parts list -
4) the quantity required.
REPLACING THE ROLLER COVERING
1. Remove the cover sheet and flannel. Wind off the steelwool, completely exposing the roller.
2. Take a new roll of steelwool, cut one and off diagonally and place on the left-hand side of the roller with a
slope of approx. 30 degrees. Keep tight.
3. Begin winding towards the right-hand end with the ironing plate under pressure, taking care not to overlap the
edges; then take a second layer from right to left in the same way. Repeat this operation until the
circumference of the roller reaches 910 mm.
4. Spread the flannel evenly over the padded roller and tighten with the ironing plate under pressure until it is
fully wound. Raise the temperature to approx. 130°C and let the roller rotate for a few minutes until the
flannel cover is settled.
5. Place the narrowest end of the cover sheet approx. 10 cm under the edge of the flannel, making sure it is
perfectly smooth and parallel. Put the ironing plate under pressure and wind the sheet round. Let the roller
rotate for a few minutes. When the cover sheet is settled, secure the ends.
Every maintenance operation must be carried out by professionally qualified personnel.
REPLACING THE COMPLETE ROLLER
Prior to carrying out any inspection or work on the ironer, make sure that it is disconnected
from the mains power supply.
1. Remove the side panels and the feeding table. Disconnect
the contact of the emergency stop button by pressing with
a screwdriver the metallic hook, disconnect the probes
terminal and the flat cable for card supply.
2. On the right hand side unlock the screws fixing roller
motor using an open end wrench M13 and a setscrew
wrench M5 to easily remove the chain.
3. Remove the rim for roller (pos. 55) using a setscrew
wrench M8 and an open end wrench M17.
4. On the left hand side remove the manifold for exhaust
system (pos. 21) and the ring that locks the roller (pos.
22) using respectively a setscrew wrench M3 and M4.
5. On both sides remove roller supports (pos. 23) with an
open end wrench M13.
Right side plate
14/27
Содержание E 140.30
Страница 2: ...2 27 ...
Страница 28: ......
