Gmini GM1705, Инструкция по эксплуатации

Страница: 30 / 60

PRODUCT CARE AND MAINTENANCE
REMOVING THE CHILD SAFETY SEAT COVER
If you want to wash the child safety seat, then simply
open up the harnesses and remove the cover. When
performing these tasks do take care that you push the
harness adjustment button through as depicted in figure
no. 30.
When washing precisely observe instructions. We
recommend that for the first wash you use an agent that
protects colors. Protector must be added to water during
rinse cycle. Harness, buckles and plastic parts may be
wiped with a wet cloth. Do not use paint thinners or
bleaches as these could damage and limit functionality.
If you want to install / remove sun canopy, proceed
according to steps in the previous paragraph.
Wash at 30⁰C
Do not bleach
Do not dry
Do not iron
Do not dry clean.
CLEANING THE CHILD SAFETY SEAT
"Y" belt and plastic parts can be washed using a mild detergent and warm water.
To wash the child safety seat do not use chemical cleaning agents, bleaches or corrosive cleaning
products.
MOUNTING THE CHILD SAFETY SEAT ON A STROLLER
Gmini child safety seat can be mounted on a Gmini brand strollers, which are equipped with
necessary system using the Gmini adapter (can be purchased separately)
– see figure 31.
Always check in the corresponding stroller's manual, if a child safety seat can be mounted on the
stroller.
1. Open the stroller as per the instructions in corresponding owner's manual.
2. Place the child safety seat on a flat and steady surface and set the carry handle into horizontal
position.
3.Insert the adapter into the openings on the stroller chassis (Fig. 32) , make sure to check the L/R
sides are in their places
– see figures 33 1,2,3.
4. Afterward place the child safety seat on the adapters, the child safety seat must be placed facing
the parents. Once properly secured, you will hear the safety click. Check that the seat is secured
properly on both sides - see figures 34 - 3, 3A, 3B, 4.
5. If you want to remove the child safety seat from the stroller, then press both buttons on the sides of
the child safety seat - see figure 38.
6. Place the product on a flat and stable surface and then move the carry handle into vertical
position.
ATTENTION! Child safety seat can be mounted or released, even if a child is in it; however the steps
stated above may be more difficult to perform due to the weight of the child.
7. To release the adapter from the stroller chassis, simply pull on the safety mechanism (fig.37-5) and
pull the adapter outward (fig. 37-5A). Then repeat the same task for the second adapter mechanism.