Page 28
2669-RT / 3369-RT / 4069RT
Frequent Inspection Checklist
This checklist must be used at 3-month intervals or every 150 hours of machine use, whichever occurs
first. Failure to do so could result in death or serious injury.
Frequent Maintenance Inspections should be conducted by qualified service technicians only. Photocopy this page for reuse. Keep
inspections records up to date. Record and report all discrepancies to your supervisor.
Model Number ________________ Serial Number ________________________ Hour Meter Reading ________________
Initial
Description
______
Perform all checks listed on Pre-Start Inspection.
______
Inspect the condition of hydraulic fluid in the reservoir. Oil should be a clear amber color.
______
Check battery electrolyte level and connections.
______
Check wheel lug bolts for proper torque (see “Machine Specifications”).
______
Check if tires are leaning in or out.
______
Inspect all structure and pivot points for signs of wear and/or damage.
______
Check the pin joints and retaining rings for security.
______
Inspect the entire machine for signs of damage, broken welds, loose bolts, improper or makeshift repairs.
______
Check that the platform does not drift down with a full load.
______
Check all wire connections for tightness and corrosion.
______
Check outriggers (if equipped) for proper operation.
______
Check the operation speeds to ensure they are within specified limits (see
Specifications
).
______
Check the emergency lowering system.
______
Clean and lubricate all push button switches with dry lubricant and ensure that the switches operate freely in all
positions.
______
Check the tightness of the platform frame and the linkage pins.
______
Check the overall platform and guardrail component security.
______
Check the electrical mounting and hardware connections for security.
______
Check the steering kingpins for excessive play.
______
Consult the Kubota engine manual for details regarding other engine checks and change intervals for filters and fluids.
Additional maintenance requirements for severe conditions
______
If the machine is used in very dusty, exceptionally hot or exceptionally cold conditions,
replace engine air filter element and hydraulic filter element (under normal conditions replace every 6 months or 300
hours, whichever comes first).
1OP69
– January 2018
Machine Inspections