G - D E K
i n s t r u c t i o n m a n ua l
Pa G E 1 0
Flush mounting
Before starting, select a suitable panel for the mounting
location then examine behind the panel to determine that
there is sufficient access for routing the cable and fitting the
mounting screws. a template is included for marking the
mounting locations.
screw mounting
For a screw mounted installation, place the template against
the mounting surface and mark the location of the four
mounting screws and the connecting cable. Drill the holes
using sizes marked on the template. Feed the remote head’s
interface cable through the centre hole in the panel and
position the remote head against the panel with the mounting
holes aligned. install the four screws from behind the panel.
adhesive tape mounting
the G-DEK remote head can be fixed to a flat surface using a
good quality ‘Very High Bond’ double sided adhesive tape such
as 3m VHB 4991 or equivalent.
For an adhesive tape mounted installation, place the template
against the mounting surface in the desired position ensuring
the template is level. mark the location of the hole for the
interface cable. Drill the hole for the interface cable using the
size marked on the template.
clean the rear of the remote head unit with isopropyl alcohol
in the locations where the adhesive tape will be applied (as
shown in the diagram). apply good quality ‘very high bond’
adhesive double sided tape to these locations.
similarly, clean the surface of the
mounting panel using the
isopropyl alcohol.
FlusH mount usinG scrEWs
