GM-Racing 90163.RTR Low Rider Monster Truck 4WD, Инструкция по эксплуатации

Страница: 11 / 32

90163.RTR Low Rider Monster Truck 4WD 10
have enough voltage or the car battery is fully charged and change it and/or recharge if necessary.
The run time with a fully charged battery is between 15 and 30 minutes, depending on the battery and surface. In high
grass the run time is naturally shorter than on the
fl at road. When the battery dumps, fi rst the car runs slower, then the
speed controller completely switches off and the vehicle stops. After driving take the battery out of the vehicle, otherwise
uncontrolled starting of the motor may damage the speed controller or the batteries.
After driving take the battery out of the vehicle, otherwise uncontrolled starting of the motor may damage the speed
controller or the batteries.
Don‘t drive against obstacles, which the model cannot overcome, and stay on full throttle. This can destroy the engine,
electronic speed controller or the transmission!
Don‘t drive in wet grass or puddles, because the electronic equipment (servo, receiver and speed controller) is not wa-
terproof. If you want to drive in the wet, these parts must be protected waterproof (e.g. by a ballon).
CHECKLIST BEFORE YOU START
Check all screws on permanent seat. •
Check all the moving parts to work without binding. •
Check the batteries in the remote control. •
SERVICE
In addition to the already described service work should always try to keep your vehicle in order to prevent wear. If there
is dirt in moving parts, this can affect the performance of the model signi
fi cantly. Remove dirt or dust with compressed
air, a soft brush and / or with a toothbrush. If possible, try using no solvents, as this can move the dirt in normally inac-
cessible places and thus cause additional wear. We recommend the following simple procedures:
Remove dirt and dust as far as possible with the methods described above. •
Check the car for worn, broken or gripping parts and repair them if necessary. •
Check regularly the fi xed seating all screws and tighten them if necessary. •
TOOLS REQUIRED
Allen key 1.5, 2 und 2.5mm (order-no. 5775.1,5; 5775.2 and 5775.2,5 or 5774) •
5.5 und 7mm wrench (order-no. 5783.5,5 and 5783.7,0) •
17mm Wheel nut wrench (order-no. 98004) •
small needle-nosed pliers •
Allen key 1.5, 2, 2.5mm
Wrench 5.5mm, 7mm
Needle-nosed pliers Wheel nut wrench
SERVICE AND REPAIR, SPARE PARTS
For the Low Rider all parts are available as spare parts. So if a part is defective or worn, you can identify these parts with
the Exploded view, buy these parts and
fi x the car yourself with the help of the assembly instruction (pages 22 - 29).
In problem cases, or for questions and repairs, please contact the Service department in your country (see
warranty card on page 30) or:
GRAUPNER-Service, Henriettenstrasse 94-96, D-73230 Kirchheim/Teck,
Tel. +49/1805/472876
SPARE PARTS: at your local hobby shop or online at Graupner spare-parts Shop http://www.graupner-ersatzteilshop.
de/ under order.-nr.: 90163.RTR