GLP impression FR1O BAR, Быстрый старт и руководство по безопасности

Страница: 15 / 28

German Light Products®
Impression FR10 Bar Quick Start and Safety Manual Rev. A
15
Installing on a rigging truss or similar structure
You can suspend an FR 10 Bar fixture from a rigging truss or pipe using the brackets that
are supplied with the fixture and rigging clamps that are available from GLP as
optional accessories.
If you are going to install the fixture hanging vertically downwards from a horizontal
rigging truss or pipe, you can fasten it to the truss using G-clamps. If you are going to
install the fixture in any other orientation or if the rigging truss is not horizontal, you must
use half-coupler clamps that completely surround the truss chord or pipe. Rigging
clamps must be approved for the weight that they will support.
To install the FR 10 Bar on a rigging truss or pipe:
Check that the truss or pipe is secure and can safely hold ten times the weight that
it will support.
Using high-tensile steel screws or bolts and self-locking nuts, bolt at least one rigging
clamp to each of the two installation brackets that are supplied with the fixture.
See Figure 7. Fasten the two brackets A supplied with the fixture to the bottom of
the base using four quarter-turn fasteners B per bracket. Turn each fastener a full
90° to lock it.
Hold the fixture up to the truss and use the rigging clamps to fasten the fixture
securely onto the truss chord.
If there is any risk that the fixture will cause injury or damage if it falls, secure it with a
safety cable that is approved for the weight of the fixture, rigging hardware, cables
etc. as described in ‘Securing the fixture with a safety cable’ on page 13.
Figure 7. Brackets and rigging clamps
A
C
B
B