German Light Products®
Installation
Fusion XPAR 12Z Quick Start and Safety Manual Rev. A
17
Free standing on a flat surface using mounting bracket
You can use the XPAR 12Z fixture free standing on the floor or other flat horizontal surface
by splitting the mounting bracket into its two sections and positioning them at an angle to
form two feet for the fixture to stand on.
The vertical angle of the fixture can be adjusted by varying the mounting bracket position.
Figure 5. Free standing on a surface
1. Loosen the handwheel bolts either side of the mounting bracket.
2. Split the bracket into its two sections and position them at 90 degrees to each other as
shown in Figure 4.
3. Adjust the vertical angle of the fixture by swivelling the fixture within the mounting
brackets.
4. Tighten the handwheel bolts.
5. Ensure the fixture is located in a position where it will not form a trip hazard or cause
injury if it falls over. If in doubt secure the fixture with a safety cable to an adjacent fixed
point.
