Supplied By www.heating spares.co Tel. 0161 620 6677
20
221098C
6 I n s t r u c t i o n s t o U s e r
5 L i g h t i n g , T e s t i n g a n d F i t t i n g o f I n t e r n a l P a r t s
Diagram 6.1
MATCH OR
SPILL
Diagram 5.19
5.6 Plinth Fitting
Fit the controls cover plinth onto the guides and push it
back as far as it will go, see diagram 5.19.
Hand the Instructions for Use to the user and instruct in
the safe and economical use of the fire front and back
boiler.
Advise the customer that they should read their Users
instructions before operating the fire and always follow
the advice in the Section headed “Cleaning your Fire”.
Advise that any smell which may be apparent on initial
lighting is quite normal and it will quickly disappear.
Important: Advise that soft wall coverings, for example,
blown vinyl wallpaper, are easily affected by heat, they
may, therefore, scorch or become discoloured when
close to a heating appliance. This should be borne in
mind when having a heating appliance installed and
when redecorating.
Advise the user, to ensure the continued efficient and
safe operation of the appliance it is recommended that it
is checked and serviced as necessary at regular intervals.
The frequency of servicing will depend upon the
particular installation and usage, but in general once a
year should be enough.
Draw attention, if applicable, to the current issue of the
Gas Safety (Installation and Use) Regulations, Section
35, which imposes a duty of care on all persons who let
out any property containing a gas appliance.
It is the Law that servicing is carried out by a competent
person.
Show how to light the fire front, in the event of a power
or ignition system failure, with a spill or long match, see
diagram 6.1.
Remove the front casting.
Hold a lighted spill or long match and insert it beneath
the front lighting assembly, position the spill so that the
flame is over the burner.
Keep the spill in position, push in and turn the gas tap to
position 1 and the burner will light keep knob pushed in
for about 10 seconds and the burner will stay light.
If the burner should go out repeat the above operation,
but now keep the knob pushed in for a little longer.
Once lit operate the gas tap normally.
This is a temporary measure only and the fault must be
put right as soon as possible.
Advise the user of the precautions necessary to prevent
damage to the system, boiler and the building, in the
event of the heating system being out of use during frost
or freezing conditions.
Advise that the fire front is fitted with a safety device
and refer to the instructions for use.
Reminder, leave these instructions with the user.
MATCH
EXTENSION
BURNER
5338
3951 S
PLINTH