Gloria ProControl 100, Инструкция по эксплуатации и техническому обслуживанию

Страница: 9 / 26

Seite/Page 9 von/of/de 26
Important!
These instructions must be closely observed for safety reasons. Failure to observe these
instructions may cause serious danger.
1. Safety instructions
•
Do only use approved spray materials. The manufacturers
’ instructions for
spray materials must be observed exactly.
•
Do not use inflammable liquids because of the explosion danger, not even for
cleaning purposes.
•
Do not use corrosive or caustic liquids as these can ruin metal parts, seals,
gaskets, washers and hoses.
•
Never start to operate if there is any visible damage in or outside the tank. Hose
line must be connected with tank and trigger. Check condition of hose, it should
not be too soft, hard or cracked.
•
Pressurize only with the installed hand pump. Do not pump with head or body
over the pump.
Use of air compressors or other mechanical devices for pressurization is not
recommended.
•
The tank must be completely depressurized:
- before servicing at any time
- before removing the pump
- before removing hose line from tank, nozzle and other parts
- before opening hand tube for cleaning the strainer
- before opening cover lid
- when sprayer is left in sun or other warm place
•
Empty and clean tank and hose line immediately after each use (see
instructions on page 5).
•
Children are not allowed to operate with this sprayer. Store spray materials
always under lock and key. Do not leave or store the sprayer in a pressurized
condition.
•
Only by using original GLORIA spare parts can the safety and efficiency of the
unit be guaranteed. Fitting of spare parts only to be done by trained staff.
•
The tank will withstand twice the maximum working pressure (8 bar) without
deforming or leaking.
2. Starting to operate
2.1 Spraying lance
Connect (screw) spraying lance and trigger (fig. 1).
Fig. 1