21
Glomar AG
l
Seestrasse 11
l
CH-9326 Horn
l
T +41 71 841 70 70
l
www.glomar.ch
21
AS85
english
L
Danger:
the cutting head is the only part of the tool that presents a mechanical
hazard!
L
Warning:
the tool must only be operated using original Intercable battery units!
L
Warning:
remove the battery if the tool is not used for long periods of time!
A
Warning:
do not use the device in areas where there is danger of explosion!
L
Danger:
Removing the battery and returning the tool to starting position is is the
only way to guarantee complete disconnection from the electricity supply!
L
Warning:
if an oil leak occurs, send the cutting tool to an Intercable service centre!
A
Warning:
do not use the cutting tool in driving rain or under water!
L
Warning:
hydraulic oils contaminate ground water. Oil spillage and improper disposal
are liable to prosecution (in accordance with environmental protection regulations)!
5. Storage and transportation
We recommend cleaning the AS85 cutting tool thoroughly after use in order to protect it
from damage. To store the tool, use exclusively the carry case and make sure it is closed
properly. The cutting tool must at all times be transported in the carry case provided,
which must be closed, and must be used only by persons in good physical condition.
6. Maintenance instructions
After every use, clean the cutting tool and store in a dry place. The battery and battery
charger must be protected from moisture and foreign bodies. As a rule, the device
does not require maintenance. After 3 years or 20,000 work cycles, the cutting tool
must be sent to the maintenance centre in order to guarantee correct working order
and increase its working life. The customer is not authorised to carry out maintenance.
Repairs to the tool must be carried out exclusively by qualified technicians using only
original spare parts, so as not to compromise the safety of the device
