8
6. Front panel
ROOM 1 CONTROL:
POWER KEY:
To switch the Room 1 receiver power on/stand by
v ,^ KEY :
To change channels in Room 1, or to move cursor up or down in the menu
Display(4-Digit/7-Segment):
Indicates operating status of Room 1 receiver
VOL<,> KEY:
To adjust Room 1 volume level, or to move cursor left or right in the menu
MENU KEY:
To enter into the Room 1 main menu
OK KEY:
To see Room 1 TV/Radio channel list, or to confirm in the menu
Exit:
Cancel the Room 1 user selection and return to the viewing mode from a menu.
POWER Led 1:
Lights up while the Room 1 receiver is in standby mode
Signal Led 1:
When Room 1 receiving signal is strong, the signal led is lighted.
Remote Sensor:
Detects infrared signal from remote control unit, only for Room 1.
ROOM 2 CONTROL:
POWER Led 2:
Lights up while the Room 1 receiver is in standby mode
Signal Led 2:
When in Room 1 receiving signal is strong, the signal led is lighted.
Card Slot:
One slot CA interface for Conax. Insert the Smart Card chip side up.
7. Rear Panel
Please refer to the diagram below for all possible connections of your receiver
Do not connect the unit to the mains socket until all other connections have been made and
checked.
For Room 1 only:
RF IN :
This input port is to connect the coaxial cable from your Cable Network provider.
RF OUT:
This output enables the connection of another receiver.
TV:
This output is used to connect your TV through SCART cable.
VIDEO OUT:
This output RCA connector is used to connect any external video.
AUDIO R/L:
These output RCA connectors are used to connect any external audio amp or system.
