Globe 3600N, Инструкция по эксплуатации

Страница: 11 / 24

Page 11
ALWAYS
operate the slicer with the knife cover, sharpener, and knife ring guard securely in
place. Failure to do so will cause serious personal injury.
AUTOMATIC SLICER OPERATION
1. Make sure the slicer is turned off (power indicator light is not illuminated). Make sure the auto engage lever is
in the “Manual” position and the food chute moves freely.
2. Pull the food chute completely towards you and place the food product onto the food chute. Slice only boneless,
unfrozen product with the slicer. (Models 3600NF and 3850NF is recommended for slicing frozen product.) Swing
the end weight into position to secure food product.
3. If the food product is too long, place the end weight on top of the food product and use the end weight prongs
to hold the food product in place.
4. Rotate the slice thickness dial counterclockwise to the desired setting. If you happen to go past the desired
setting, you must first rotate the slice thickness dial clockwise past zero (0) and then rotate the dial back to the
desired slice thickness setting. After slicing is complete, always turn the slice thickness dial clockwise past zero
(0) until it stops to close the slicer table.
5. Press the start button. The power indicator light will illuminate. If the speed light is flashing, then the auto
engage lever is in the “Automatic” position. Press the stop button to turn off the machine. Lower the auto engage
lever to the “Manual” position and restart the unit.
BE ALERT. The next step will cause the food chute to move automatically and it can move either
direction on start up.
NEVER attempt to adjust, load or unload food chute when slicer is in
automatic operation.
NEVER put hand into the chute arm opening on the right side of the slicer.
6. To make the food chute move automatically, pull up or raise the auto
engage lever into the “Automatic” position (Fig. 11-1).
a. Model 3850N – To adjust the chute speed, press the faster button for 60
strokes per minute and the slower button for 40 strokes per minute.
b. Model 3975N – To adjust the chute speed, press the slower
or faster buttons. The slicer defaults to speed 5 when the power cord is
unplugged and plugged back in. If the slicer is turned off but not unplugged,
it will return to the last speed used.
NOTE: Chute speed can be adjusted prior to, or after, auto engagement.
7. To stop the automatic movement of the food chute, push down or lower the auto engage lever to the “Manual”
position.
The knife is still rotating even though the chute has stopped.
8. To turn the slicer completely off and stop the knife, press the stop button. If the auto engage lever has not
already been returned to the “Manual” position, push down or lower the lever to the “Manual” position.
Operating Instructions
Figure 11-1
Auto Engage Lever