GLOBBER ONE K E-MOTION 4, Руководство пользователя

Страница: 8 / 226

7 - MAINTENANCE
• Warning. As with any mechanical component, your product is subject to high
stresses and wear. The various materials and components may react differently to
wear or fatigue. If the expected service life for a component has exceeded, it may
break suddenly, therefore risking causing injuries to the user. Cracks, scratches
and discoloration in the areas subject to high stresses indicate that the component
has exceeded its service life and should be replaced.
• Caution: the rear wheel has a motorised part which can only be dismantled or
changed by a qualified technician.
• Do not change any motorised parts yourself or the warranty will be invalidated.
Contact your dealer for a qualified technician or contact Globber,
contact@globber.com
• The lithium battery: To guarantee the battery lifetime, charge it when its level is
low. If it is not used for a long period of time, you are advised to charge it once a
month. If you wish to check the battery or change it, contact a qualified technician
or a Globber representative.
The recommended storage temperature for the battery is between 5°C and 30°C.
• Do not use or place the electric scooter in an environment where the temperature
exceeds 40°C to avoid any lithium battery malfunction which may lead to it
catching fire.
• Never store the electric scooter in a car during hot weather to avoid any danger of
this.
• Bearings: avoid riding through water, oil or sand which would damage your
bearings. To maintain your bearings, check regularly that the front wheel turns
properly by turning the electric scooter upside down and pushing the wheel with
your fingers. If the front wheel does not turn, remove it and check the condition
of the bearings. First unscrew the wheel axle. Remove the axle and remove the
wheel. Carefully push the two bearings out of their seating. If they are chipped or
crushed, buy new ones. If there is no visible damage, oil them. To do so, remove
any traces of grease, mud or dust from the bearing using a paper towel or a cloth
then grease them either with a self-lubricating spray or by soaking them in oil
overnight (turn the bearings several times in the oil before leaving them to soak).
Refit the bearings and axle, then the front wheel.
• The wheels: the wheels wear out after a certain length of time or may even
develop holes if the scooter is used on rough surfaces too much. This is
particularly true of the rear wheel on which the brake is applied. Check them
regularly and have them changed for better safety.
• Product modifications: the original product must by no means be modified except
for the maintenance-related changes mentioned in these instructions.
• Nuts, axles and other self-locking fasteners: these should also be checked
regularly. They can become loose after a while in which case they should be
tightened. They can become worn and not tighten properly, in which case they
should be replaced.
8 - DISPOSAL OF END-OF-LIFE APPLIANCE
• The appliance must be disconnected from the mains supply when removing the
battery.
• The battery must be removed from the appliance before the appliance is
discarded.
• The battery must be disposed of safely by taking it to the most suitable collection
point.
8
ENGLISH