GlobalTime
®
Single- sided Analog Wi-Fi Clock
GlobalTime Electronic Co., Limited
Tel: +86 21 3563 1186 Fax: +86 21 3653 1185
Add: Floor 7, Building 4, No. 651, Wanfang Road,
Web: www.ntpclock.com
Minhang District, Shanghai, China /
201112
Email: [email protected]
User Guide
1. Pull out the dowel pin on the back of the clock.
2. Insert 2 alkaline batteries to power the clock. Press and release the button “REC” on the movement. This
puts the clock into “Direct Mode”.
Dowel Pin
REC
3. On a Wi-Fi enabled computer or a smart phone, check the available Wireless Network. Refresh the
available networks until a network named GTC_###### appears (where ###### is the serial number
of the clock). This may take up to 30 seconds. Once it appears, connect to this network. Then the
configuration web page will appear automatically, if not, we can open a web browser and enter the
following web address or any web address into the URL filed:
4. In the password filed, enter the password of your preferred Wi-Fi network.
5. In the Wi-Fi Setting filed, enter the SSID and password of your preferred Wi-Fi network. This is the name
that appears if you try to connect to that Wi-Fi network on any other computer, tablet, or smart phone. If
you do not remember the name of your network or are unsure of the spelling, check to see if it has
appeared in the Select Network list. A network that does not broadcast its SSID will not appear in this list.
6. If you wish to set a static IP address, change DHCP Auto On from ON to OFF, then enter information for
the Static IP address, Subnet Mask, and Gateway Address. To acquire this information, contact your
network administrator.
7. If you wish to set a NTP server other than the one provided, enter an
IP address
for a new NTP server in
the NTP Server field.
Notes. The first time we set the clock, the configuration will take effect immediately. When we change the configurations in future, the
configuration will take effect until the clock synchronize the next time. If we can not wait, we can press the button “REC” or reboot the
clock then the configuration can take effect immediately.
